Happy Chinese New Year!
Our office will be closed Feb 1–8 and will reopen on Feb 9.
100M/pack SMD 2835 39.4" Cut 360 Degree Round LED Neon Strip Flexible Light 120Leds/M 220VAC Waterproof
Unit cost
THB 50,322.00
/unit
Wholesale discounts
Quantity
Discount
Price per unit
1
0%
THB 50,322.00
Total Cost
THB 50,322.00
Amount
/unit
1
Features:
Advantages of high quality LED flexible neon light:
1.overall luminous uniform, no stain, no black spots.
2.little weld, touch foot phenomenon, will not cause a short circuit or not bright.
3.main line uses 21 core wire, not easy to break the main line, so as not to cause the whole is not bright.
4.in the core material is thick; pin inserted is not easily damaged, is not easy to cause short circuit burned.
5.the surface is smooth, the rubber material is soft and clean, and has no impurity; the material is full, and the feeling is very good; the shear mouth is correct.
6.beads with domestic stable supply manufacturers, batch color small, uniform brightness.
7.complete Accessories, fine packaging ( with high-grade rubber roller, not easily broken ), containing detailed installation instructions.
8.after the installation is not easy to out of the problem, long service life, reduce maintenance costs.
Introduction:
Product size: H18x W18mm
Light Angle: 360°
LED lights: 76 lights / meter
Work rate: 10W / M
Voltage selection: 220VAC
Colloid color: White
Waterproof grade: IP67
Working temperature: -30°C~50°C
Ultra high brightness solid-state cold light source LED
Guarantee period: 2 years
Unit cut length: 100cm(39.4") (scissors mouth position cut)
Note: the weight per meter is about 208g
Installation instructions:
1.First install the LED flexible neon light plug, test whether the light belt can be bright;
2.Put the whole coil of light up with a wooden stick and slowly install it on the wall. (avoid by all means: it is not allowed to remove all LED flexible light strips from the glue shaft and then pull them up to the height, which may easily cause the main line of the light to break);
3.When there is no light in the middle of the installation; Cut out the dull whole unit, and then use the middle butt joint (or the front and back joint) to connect the two sides, if installed in the outdoor, the joint should be made of silicone waterproof.
